|
Post by Mike on Apr 4, 2009 18:08:09 GMT -5
Does any one have the dimentions for the snowplow kick stand? Ours is missing.
|
|
|
Post by Mike on Apr 19, 2009 21:56:01 GMT -5
No one has a 48 inch snow plow for an 800/8000 series rider that has a kick stand?
|
|
|
Post by Skools Out on Apr 20, 2009 17:45:57 GMT -5
are you taking about the blade type with the little spring loaded stand?
|
|
|
Post by Mike on Apr 21, 2009 23:35:22 GMT -5
I guess so. I have never seen one and our blade is missing it. I am guessing it holds the back of the blade mount up to where you can drive up to it to hook it into the rear mounts.
|
|
|
Post by Skools Out on Apr 23, 2009 21:07:13 GMT -5
yeah it kind of does holds mine to high lol
|
|
|
Post by Skools Out on Apr 23, 2009 21:07:55 GMT -5
i'll get you a picture and measure it tomorrow if i remember
|
|
|
Post by Mike on Apr 23, 2009 21:53:48 GMT -5
Thank you!
|
|
|
Post by Skools Out on Apr 24, 2009 22:23:50 GMT -5
|
|
|
Post by Mike on Apr 24, 2009 23:26:37 GMT -5
Thank you very much! I get tired of laying on the floor to hold up the rear of the blade frame and have to roll the tractor foward. I will have to try and make one.
|
|
|
Post by Skools Out on Apr 24, 2009 23:31:38 GMT -5
one helping bit of info ours is to high to just drive up to i have thought of shorting it. to get the right size for your tractor park it on flat ground with the blade hooked up measure from the hole to the ground then make the stand that length or just a hair shorter so you can fold it down still on the tractor then back out and the place where it will load and line itself up when loading. just a thought.
|
|
|
Post by Skools Out on May 4, 2009 8:55:13 GMT -5
did those help to make one? let us see
|
|
|
Post by Mike on May 4, 2009 22:00:15 GMT -5
I haven't had time yet to make one. I hope to sometime soon as I have be busy with my dirt project and getting ready for exams at school. But will show pics when it is done!
|
|